scrape off frost or ice. Frost may be removed byY Parts which heat up should not be exposed.
Het wijzigen van de deur-
using the scraper provided. Under no circum-Wherever possible the back of the product
stances should solid ice be forced off the linershould be against a wall..draairichting
Solid ice should be allowed to thaw when
Y If the appliance has been transported horizontal-Neem v??r het wijzigen van de deurdraairichting
defrosting the appliance. See defrost instruc-
ly, it is possible that the oil contained in the com-de stekker uit het stopcontact.
tions.
pressor flows in the refrigerant circuit. It is advis-
Ga nu verder als volgt te werk:
Y Do not place carbonated or fizzy drinks in theable to wait at least two hours before connectingG
freezer as it creates pressure on the containerthe appliance to allow the oil to flow back in the,1. Ventilatierooster (D) verwijderen;
which may cause it to explode, resulting in dam-compressor.2. Verwijder het kapje (G) en het onderste
age to the appliance. Do not use a mechanicalscharnier (E) door de 3 schroeven waarmee
device or any artificial means to speed up thehet scharnier vastzit los te draaien.
Environment Protection
thawing process other than those recommended3. Deur van bovenscharnierpen (G) trekken.
by the manufacturer. Never use metal objects for4. Bovenste scharnierpen verwijderen en aan de
This appliance does not contain gasses which
cleaning your appliance as it may get damaged.tegenovergestelde kant weer monteren, na deG
could damage the ozone layer, in either its
dopjes verwijderd te hebben. Monteer de dop-
refrigerant circuit or insulation materials. The
Installation jes nu aan de andere kant.E
appliance shall not be discarded together with
5. Draai met een sleutel van 10 mm de scharnier-E
Y During normal operation, the condenser andthe urban refuse and rubbish. Avoid damaging
pen (E) los en breng deze aan de andere kantFF
compressor at the back of the appliance heat upthe cooling unit, especially at the rear near the
van het scharnier aan.
considerably. For safety reasons, minimum venti-heat exchanger. Information on your local dis-F
6. Plaats het onderste scharnier (E) weer aan de
lation must be as shown in the relevant Figure.posal sites may be obtained from municipal
andere kant en maak daarbij gebruik van de
authorities. The materials used on this appli-
Attention: keep ventilation openings clear ofvier schroeven die u daarv??r verwijderd heeft;D
ance marked by the symbol are recicable.
obstruction.doe het kapje (F) uit het ventilatierrooster (D)
door het in de richting van de pijl te duwen enF
Y There are working parts in this product whichPR18
breng dit aan de andere kant aan.
heat up. Always ensure that there is adequate
7. Deur herplaatsen.
ventilation as a failure to do this will result in
8. Ventilatierooster weer terugplaatsen (D).
component failure and possible food loss. See
9. De Handgreep losschroeven en aan de andere
installation instructions.
kant van de deur bevestigen nadat u de dopjes
met een priem doorgeprikt heeft. De vrijgekomen
gaatjes afsluiten met de bijgeleverde dopjes;
deze vindt u in het zakje van de documentatie.
Belangrijk:
Controleer na de richting van de deuren gewijzigd
te hebben, of alle schroeven goed vastgedraaid zit-PR220
ten en of het deurrubber goed op de sponning sluit.
CONTENTS
In een koud vertrek (in de winter) kan het gebeuren
dat dat niet het geval is. Na enkele dagen zal het
Warnings .................................................................................................................................................11
rubber zich echter aangepast hebben. Wilt u dat
Use - Cleaning the interior - Operation - Temperatureregulation - Fresh food refrigeration ..................... bespoedigen, dan kunt u het rubber warm maken
met een fšhn.
Movable shelves - Positioning the door shelves .......................................................................................13
Hints- Hints for refrigeration - Maintenance- Periodic cleaning - Periods of no operation ..................
Interior light................................................................................................................................................14
Maintenance - Defrosting - Customer service and spare parts - Technical Information..................15
Installation- Location - Rear spacers - Electrical connection .................................................................16
Installation - Door reversibility .................................................................................................................17
129 |